http://bugzilla.novell.com/show_bug.cgi?id=502193 User nice@titanic.nyme.hu added comment http://bugzilla.novell.com/show_bug.cgi?id=502193#c9 Tamás Németh <nice@titanic.nyme.hu> changed: What |Removed |Added ---------------------------------------------------------------------------- Status|NEEDINFO |NEW Info Provider|nice@titanic.nyme.hu | --- Comment #9 from Tamás Németh <nice@titanic.nyme.hu> 2009-05-13 08:12:06 MDT --- (In reply to comment #8)
The options look fine (apart from the stray space after the comma in com1=, which might well be an issue with how you inserted that information here), and there are no kernel options needed for this to work. Does the serial port use the usual port and irq? Btw, while I have no reason to believe this works, I never ran Xen's console at this low a baud rate...
Finally I was successful with these settings: kernel /boot/xen.gz com1=38400,8n1,0x3f8,4 console=com1 loglvl=all guest_loglvl=all I saw a lot of output on the remote machine. Then after booting, I issued the command: echo mem > /sys/power/state The machine went suspended successfully (?), but after turning it on, I saw no messages on the serial console despite that I pressed the d key (on the remote machine, of course). I also pressed enter afterwards but still no results. -- Configure bugmail: http://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.