https://bugzilla.novell.com/show_bug.cgi?id=376337 Summary: Hauppage Hvr 3000 TV card not supported Product: openSUSE 10.3 Version: Final Platform: i686 OS/Version: openSUSE 10.3 Status: NEW Severity: Normal Priority: P5 - None Component: Other AssignedTo: bnc-team-screening@forge.provo.novell.com ReportedBy: lee_matheson@hotmail.com QAContact: qa@suse.de CC: lee_matheson@hotmail.com Found By: Other The Hauppage Hvr 3000 TV card is not supported in an "out of the box" configuration of openSUSE-10.3. The linuxtv.org wiki suggests the Hauupauge WinTV HVR-3000 may be possible to get working under openSUSE if one uses mercurial to apply the latest patch to v4l-dvb. http://www.linuxtv.org/wiki/index.php/Hauppauge_WinTV-HVR-3000 openSUSE-10.3 does not provide v4l-dvb (although it does provide a v4l-conf and v4l-toos and dvb, neither of which support the Hauupauge WinTV HVR-3000). After installation of mercurial, an effort was made to install the v4l-dvb driver for the Hauupauge WinTV HVR-3000 (see thread below) but thus far nominal performance has not yet been possible with this driver with the openSUSE-10.3 2.6.22 kernel. There is the possibility that that the patch for this Hauupauge WinTV HVR-3000 requires the 2.6.24 linux kernel (while openSUSE-10.3 comes with a 2.6.22 linux kernel) as the site below provides the v4l-dvb patches (and specifically notes the 2.6.24 kernel): http://dev.kewl.org/hauppauge/ It is also believed that this problem may be applicable to openSUSE-11.0, with a "patched" v4l-dvb opensource driver being required to support the Hauppage Hvr 3000 TV card. It is speculated that the openSUSE v4l-dvb may not have the necessary patch. Efforts to solve this problem are currently being tracked in this forum thread: http://forums.suselinuxsupport.de/index.php?act=ST&f=4&t=65825&st=0 -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.