https://bugzilla.novell.com/show_bug.cgi?id=697389 https://bugzilla.novell.com/show_bug.cgi?id=697389#c1 Marcus Schaefer <ms@novell.com> changed: What |Removed |Added ---------------------------------------------------------------------------- Status|NEW |NEEDINFO InfoProvider| |bwiedemann@novell.com Severity|Major |Critical --- Comment #1 from Marcus Schaefer <ms@novell.com> 2011-06-01 09:23:45 UTC --- the movie is nice but I should have the entire log file /var/log/boot.kiwi at hand. Would you mind to attach it. This can be done best if you attach another v-disk to the qemu run and store the file on it while in the kiwi debugging console. Thanks * does booting the iso as iso work ? qemu -cdrom file.iso ... * I have tested the Factory kiwi with 11.4 and there it still works for me. So this looks related to another change, what about isohybrid does it still work the same way as before ? kiwi calls isohybrid as follows isohybrid -id 0x828b28e6 -type 0x83 \ /tmp/mytest/LimeJeOS-openSUSE-11.4.i686-1.11.4.iso * I'm very concerned about the fdisk output you sent in the movie. It displayed: Device Boot Start End Blocks Id System /dev/vda1p1 * 0 1409023 704512 0 Empty there is no System identified and I bed the mount of vda1 will fail which is the reason why the mbrid can't be found. If booting as cdrom works this is imho a bug in the partition table written by isohybrid In my test Id is 83 and System is Linux -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.