https://bugzilla.novell.com/show_bug.cgi?id=335532#c2 --- Comment #2 from Greg Johnson <greg.johnson@ctc.net> 2007-10-23 20:39:32 MST --- Did another fresh install on same laptop using splash=verbose. The first 2 attempts at an install ended up in my laptop locking up right after YAST starts up but before the main file copy part of the install. When the install process finally gets past the file copy portion and reboots, I am able to hit ESC in time when it boots from disk. Here are the last few line. Please note that when my laptop locks up, hitting the capslock or numlock keys do not cause the lights to go on and off. Having to type lines manually... Mounting local file systems... proc on /proc type proc (rw) sysfs on /sys type sysfs (rw) debugfs on /sys/kernel/debug type debugfs (rw) udev on /dev type tmpfs (rw) loop: module loaded devpts on /dev/pts type devpts (rw,mode=0620,gid=5) kjournald starting. Commit interval 5 seconds EXT3 FS on sda3, internal journal EXT3-fs: mounted filesystem with ordered data mode. /dev/sda3 on /home type ext3 (rw,acl,user_xattr) AppArmor: AppArmor initialized audit(1193178287.168.2): type=1505 info=AppArmor initialized" pid=2201 While attempting a fresh install, it normally takes a few tries to get past the initial file copy portion. Each time I get past this, it locks up everytime at this section with it initializing AppArmor. What would you recommend I do to get you my HW specs? I can try the install again and try removing ApppArmor. Thoughts? -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.