http://bugzilla.opensuse.org/show_bug.cgi?id=903889 http://bugzilla.opensuse.org/show_bug.cgi?id=903889#c10 --- Comment #10 from Giacomo Comes <comes@naic.edu> --- during the installation process the network configuration only uses a simple network interface setup (no bridge). At the end of the installation process, after all the rpm are installed and the final system configuration is created, that is when you see on screen: Save installation settings * Saving network configuration... in this moment in /mnt/etc/sysconfig/network are created the network files that are used upon next reboot. There is ifcfg-br0, ifcfg-eth0 and the wrong ifroute-eth0. I would say that it is the installer that when it decides to change the saved network configuration (from non bridge to bridge because of the KVM pattern getting installed) I does so correctly for the network interface but it forgets to adjust the routing. In 13.1 this was done correctly. The bug was introduced in 13.2. -- You are receiving this mail because: You are on the CC list for the bug.