https://bugzilla.novell.com/show_bug.cgi?id=371756 User eich@novell.com added comment https://bugzilla.novell.com/show_bug.cgi?id=371756#c38 --- Comment #38 from Egbert Eich <eich@novell.com> 2008-11-26 03:53:47 MST --- Then it's most likely done at the wrong place. Here is what I've tested: - Started installation from CD (Beta4) - After YaST has started: - switch to vc2 - edited /etc/ssh/sshd_config to allow password logins - set a root password - did: ifconfig eth0 up - did: dhcpcd eth0 - ran: rcsshd start - logged in from remote (1) - on vc2 ran /bin/sh /usr/lib/YaST2/startup/YaST.call installation inital (2) - navigated thru welcome screen purely by mouse - when 'mode' screen showed did: 'xset r on -display :0; xterm -display :0; input in xterm had autorepeat. - redid step (1) and (2) - when 'mode' screen showed did: xterm -display :0; input in xterm had *NO* autorepeat. So it is possible to turn it on doing 'xset r on'. Since I don't know what actions you are performing in YaST I cannot tell you where to turn it on. Please check your YaST command sequences and find out where you have to enable autorepeat. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.