https://bugzilla.novell.com/show_bug.cgi?id=228791 sndirsch@novell.com changed: What |Removed |Added ---------------------------------------------------------------------------- Status|ASSIGNED |NEEDINFO Info Provider| |jodosh@yahoo.com ------- Comment #25 from sndirsch@novell.com 2006-12-19 09:40 MST ------- OK. DVI via nv driver can definitely be a problem. And this one really doesn't look good (no TFT detected, instead CRT output is assumed). (II) NV(0): I2C bus "DDC" initialized. (II) NV(0): Probing for analog device on output A... (--) NV(0): ...can't find one (II) NV(0): Probing for analog device on output B... (--) NV(0): ...can't find one (II) NV(0): Probing for EDID on I2C bus A... (II) NV(0): I2C device "DDC:ddc2" registered at address 0xA0. (II) NV(0): I2C device "DDC:ddc2" removed. (II) NV(0): ... none found (II) NV(0): Probing for EDID on I2C bus B... (II) NV(0): I2C device "DDC:ddc2" registered at address 0xA0. (II) NV(0): I2C device "DDC:ddc2" removed. (II) NV(0): ... none found (II) NV(0): Unable to detect display type... (==) NV(0): ...Using default of CRT (II) NV(0): Unable to detect which CRTCNumber... (==) NV(0): ...Defaulting to CRTCNumber 0 (II) NV(0): Using CRT on CRTC 0 I still have no SLI setup available for testing. :-( I propose either to switch to the nvidia driver or create a single head configuration via SaX2. "sax2 -c 0" or "sax2 -c 1" should do the trick. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.