https://bugzilla.novell.com/show_bug.cgi?id=323541 User carlos.lange@ualberta.ca added comment https://bugzilla.novell.com/show_bug.cgi?id=323541#c67 Carlos Lange <carlos.lange@ualberta.ca> changed: What |Removed |Added ---------------------------------------------------------------------------- Status|RESOLVED |REOPENED Component|Kernel |Kernel OS/Version|openSUSE 10.3 |openSUSE 11.0 Product|openSUSE 10.3 |openSUSE 11.1 Resolution|FIXED | Version|Beta 3 |Beta 1 --- Comment #67 from Carlos Lange <carlos.lange@ualberta.ca> 2008-10-02 08:16:19 MDT --- OK, Danny. As I said, every time the boot process does not crash, I had it associated with ttyS4. Here are the outputs of setserial -g /dev/ttyS* for 10.3 (associated with ttyS1) and 11.1 (with Touch enabled) compared. 10.3: /dev/ttyS0, UART: 16550A, Port: 0x03f8, IRQ: 4 /dev/ttyS1, UART: undefined, Port: 0x0200, IRQ: 5 /dev/ttyS2, UART: unknown, Port: 0x03e8, IRQ: 4 /dev/ttyS3, UART: unknown, Port: 0x02e8, IRQ: 3 /dev/ttyS4: No such device or address /dev/ttyS5: No such device or address /dev/ttyS6: No such device or address /dev/ttyS7: No such device or address 11.1: /dev/ttyS0, UART: 16550A, Port: 0x03f8, IRQ: 4 /dev/ttyS1, UART: unknown, Port: 0x02f8, IRQ: 3 /dev/ttyS2, UART: unknown, Port: 0x03e8, IRQ: 4 /dev/ttyS3, UART: unknown, Port: 0x02e8, IRQ: 3 /dev/ttyS4, UART: undefined, Port: 0x0200, IRQ: 5 /dev/ttyS5, UART: unknown, Port: 0x0000, IRQ: 0 /dev/ttyS6, UART: unknown, Port: 0x0000, IRQ: 0 /dev/ttyS7, UART: unknown, Port: 0x0000, IRQ: 0 Assuming this new behaviour stays like this, is it possible for SaX2 to use the output of setserial and write an xorg.conf with the correct port? -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.