https://bugzilla.novell.com/show_bug.cgi?id=841937 https://bugzilla.novell.com/show_bug.cgi?id=841937#c2 Craig Ruff <cruff@ruffspot.net> changed: What |Removed |Added ---------------------------------------------------------------------------- Status|NEEDINFO |NEW InfoProvider|cruff@ruffspot.net | --- Comment #2 from Craig Ruff <cruff@ruffspot.net> 2013-12-10 01:41:30 UTC --- I don't see the PCI device number for eth1 listed in the contents of /proc/acpi/wakeup, but do see the device number for eth0, which is not in use at the moment. # grep eth1 /var/log/messages 2013-12-09T16:49:55.207257-07:00 elkhound kernel: [ 11.716824] r8169 0000:06:00.0 eth1: RTL8168c/8111c at 0xffffc90012962000, e0:cb:4e:01:47:85, XID 1c4000c0 IRQ 71 2013-12-09T16:49:55.207260-07:00 elkhound kernel: [ 11.716827] r8169 0000:06:00.0 eth1: jumbo features [frames: 6128 bytes, tx checksumming: ko] 2013-12-09T16:49:56.528808-07:00 elkhound network[713]: ..skipped eth1 device: Realtek Semiconductor Co., Ltd. RTL8111/8168 2013-12-09T16:49:56.529763-07:00 elkhound ifup[1277]: eth1 device: Realtek Semiconductor Co., Ltd. RTL8111/8168 2013-12-09T16:49:56.579370-07:00 elkhound kernel: [ 30.897868] r8169 0000:06:00.0 eth1: link down 2013-12-09T16:49:56.579389-07:00 elkhound kernel: [ 30.897875] r8169 0000:06:00.0 eth1: link down 2013-12-09T16:49:56.579391-07:00 elkhound kernel: [ 30.897900] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready 2013-12-09T16:49:56.583611-07:00 elkhound ifup[1277]: eth1 2013-12-09T16:49:56.585911-07:00 elkhound network[713]: eth1 IP address: 10.0.0.4/24 2013-12-09T16:49:56.588670-07:00 elkhound avahi-daemon[696]: Joining mDNS multicast group on interface eth1.IPv4 with address 10.0.0.4. 2013-12-09T16:49:56.589135-07:00 elkhound avahi-daemon[696]: New relevant interface eth1.IPv4 for mDNS. 2013-12-09T16:49:56.589496-07:00 elkhound avahi-daemon[696]: Registering new address record for 10.0.0.4 on eth1.IPv4. 2013-12-09T16:49:59.072365-07:00 elkhound kernel: [ 33.386491] r8169 0000:06:00.0 eth1: link up 2013-12-09T16:49:59.072381-07:00 elkhound kernel: [ 33.386502] IPv6: ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready # ethtool eth1 Settings for eth1: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Advertised pause frame use: Symmetric Receive-only Advertised auto-negotiation: Yes Link partner advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Link partner advertised pause frame use: Symmetric Link partner advertised auto-negotiation: Yes Speed: 1000Mb/s Duplex: Full Port: MII PHYAD: 0 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: g Current message level: 0x00000033 (51) drv probe ifdown ifup Link detected: yes # cat /proc/acpi/wakeup Device S-state Status Sysfs node NPE2 S4 *disabled NPE4 S4 *disabled NPE5 S4 *disabled NPE6 S4 *disabled NPE8 S4 *disabled NPE9 S4 *disabled NPEA S4 *disabled P0P1 S4 *disabled pci:0000:00:1e.0 PS2K S4 *enabled pnp:00:0c USB0 S4 *enabled pci:0000:00:1d.0 USB1 S4 *enabled pci:0000:00:1d.1 USB2 S4 *enabled pci:0000:00:1d.2 USB5 S4 *disabled EUSB S4 *enabled pci:0000:00:1d.7 USB3 S4 *enabled pci:0000:00:1a.0 USB4 S4 *enabled pci:0000:00:1a.1 USB6 S4 *enabled pci:0000:00:1a.2 USBE S4 *enabled pci:0000:00:1a.7 P0P4 S4 *disabled pci:0000:00:1c.0 P0P5 S4 *disabled pci:0000:00:1c.1 P0P6 S4 *disabled pci:0000:00:1c.2 P0P7 S4 *disabled P0P8 S4 *disabled P0P9 S4 *disabled NPE1 S4 *disabled pci:0000:00:01.0 NPE3 S4 *disabled pci:0000:00:03.0 NPE7 S4 *disabled pci:0000:00:07.0 GBE S4 *disabled -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.