https://bugzilla.novell.com/show_bug.cgi?id=665720 https://bugzilla.novell.com/show_bug.cgi?id=665720#c32 Felix Miata <mrmazda@earthlink.net> changed: What |Removed |Added ---------------------------------------------------------------------------- InfoProvider|mrmazda@earthlink.net |werner@novell.com --- Comment #32 from Felix Miata <mrmazda@earthlink.net> 2011-04-04 09:41:39 UTC --- (In reply to comment #31)
Felix? Now what is going on? As blogd works now I'd like to ask what has caused the remaining problem on our system.
host big31 http://www.smolts.org/client/show_all/pub_f2e7a2ea-9a3d-4f4e-9ee5-4a2252755b... currently on kernel 2.6.37.4-1-default as indicated in comment 28 attachment, and unlike my other test systems runs on md RAID1, simply stops part way throught init on a random basis, that is, several or more boots proceed normally, but eventually boot simply won't finish. Since comment 31 I booted it 6 straight times successfully with parallel boot disabled, then saw in the boot.msg between EOF and tail of comment 28 attachment 14 lines, 5 of which were blank, all about acpid and cpufreq. Then I reenabled parallel boot, and booted it 4 straight times normally & successfully. #5 was very slow after: Master Resource Control: previous runlevel: N, switching to runlevel: ... 3 Master Resource Control: Running /etc/init.d/before.local ... done acpid: starting up with proc fs acpid: 2 rules loaded acpid: waiting for events: event logging is off Starting acpid ... done Starting D-Bus daemon ... done Loading CPUFreq modules - hardware support not available ... skipped Checking/updating CPU microcode ... done Starting syslog services ... done That's where it sat 10+ minutes after trying to boot. Then it sat several more minutes, as CAD failed to actually cause a reboot after "INIT: Switching to runlevel: 6; INIT: Sending processes the TERM signal; INIT: Sending processes the KILL signal". I hit the reset button, then chose 2.6.37-20-vanilla, which booted normally. I then replaced 2.6.37-20-vanilla with 2.6.37.6-4-vanilla and booted normally 4 straight times, which seemed to me to indicate this was indeed an openSUSE kernel bug, until boot #5 hung even earlier than with desktop kernel, at "Starting D-Bus daemon ... done", and CAD failed to reboot again. I did notice that shutdown/reboot from boot #4 had a noticeable pause. 11.2 on same system always boots completely. # zypper wp blogd .. No providers of 'blogd' found. # ??? Where does blogd come from??? -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.