https://bugzilla.novell.com/show_bug.cgi?id=450673 User adamssl77@hotmail.com added comment https://bugzilla.novell.com/show_bug.cgi?id=450673#c1 Stewart Adams <adamssl77@hotmail.com> changed: What |Removed |Added ---------------------------------------------------------------------------- CC| |adamssl77@hotmail.com Priority|P5 - None |P4 - Low Platform|x86-64 |x86 --- Comment #1 from Stewart Adams <adamssl77@hotmail.com> 2008-12-01 21:34:22 MST --- Confirmed, I see this same problem on my Thinkpad X200, 32-bit installation. Some extra comments: - This failure did not occur on 11.0, or even on 11.1 Beta-5, it is new to RC1 - The failure apparently only occurs with certain DHCP servers: - When connecting to a broadcom AP action as a DHCP server the system can correctly pick up all fields and connect to the net. - eth0 connected to this broadcom AP also correctly picks up all DHCP config - eth0 to my corporate network can populate IP address and subnet mask, but gateway and DNS are blank - wlan0 connected to an AP configured as hub (not router) on my corporate network (to allow corp DHCP to manage) will also only populate IP address and subnet mask, but gateway and DNS are left blank - nm-tool reports gateway blank, and DNS is not populated when connected to the "bad" network -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.