https://bugzilla.novell.com/show_bug.cgi?id=231163 ------- Comment #2 from lorantruckert@yahoo.com 2007-01-06 12:10 MST ------- Here is the result of the firmware test. To start it, I have to use one of the acpi=off, acpi=noirq, or noapic kernel parameters, as in the case of the default installer to make my box running. The test has run with noapic kernel parameter. During the test, a line has appeared: plugins/thermal_trip.sh line 154: [: : integer expression expected I put only items marked FAIL and INFO: items marked FAIL: DMI information check out of spec value found EDD boot disk hinting boot device 0x80 does not support EDD ACPI passive thermal trip points changing passive trip points seems uneffective in Zone TZ0 General ACPI information DSDT was compiled by the Intel AML compiler PCI express port driver reports an invalid IRQ PCI express port driver reports an invalid IRQ MFCG PCI express* memory mapped config space E820: MCFG mmio config space at 0xe0000000 is not reserved in HPET configuration test failed to locate HPET base items marked INFO: Processor mircocode update kernel too old; the kernel does not export microcode version kernel too old; the kernel does not export microcode version CPU frequency steps supported 2 CPU frequency steps supported -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.