http://bugzilla.novell.com/show_bug.cgi?id=628698 http://bugzilla.novell.com/show_bug.cgi?id=628698#c13 --- Comment #13 from Johannes Meixner <jsmeix@novell.com> 2010-08-06 14:17:06 UTC --- FYI: It does not matter into which sub-directory under /usr/share/cups/model/ PPDs get installed because CUPS searches all of them. Therefore you could just as well keep the upstream defaults so that for example cups-drivers-splix may use /usr/share/cups/model/samsung/ or /usr/share/cups/model/splix regardless that cups-drivers uses /usr/share/cups/model/Samsung/ I.e. perhaps it is best to revert all changes and patches regarding the PPD directory in cups-drivers-splix to be in full compliance with upstream here? For example the PPDs in the hplip-hpijs package are in /usr/share/cups/model/manufacturer-PPDs/hplip/ regardless that cups-drivers uses /usr/share/cups/model/HP/ and the PPDs in manufacturer-PPDs are in various directories like /usr/share/cups/model/manufacturer-PPDs/hp/ regardless of what is used in hplip-hpijs and cups-drivers. In contrast what matters is the '*Manufacturer' value in the PPDs. It should be the same spelling for one same manufacturer to get all PPDs for this manufacturer listed under the same manufacturer name in printer setup tools (e.g. "HP" versus "Hewlett Packard" versus "Hewlett-Packard" would cause annoyance for the users who like to set up a HP printer). The '*Manufacturer' values in SpliX' PPDs are perfectly o.k.: *Manufacturer: "Dell" *Manufacturer: "Samsung" *Manufacturer: "Xerox" -- Configure bugmail: http://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.