https://bugzilla.novell.com/show_bug.cgi?id=241098 ------- Comment #3 from reitenbach@rapideye.de 2007-02-12 06:29 MST ------- I installed the MesaGLw-6.5.2-13, Mesa-devel-6.5.2-17, Mesa-6.5.2-17, libdrm-2.3.0-7 from http://download.opensuse.org/distribution/SL-OSS-factory/inst-source/ because of the newer versions there available. SaX2, xorg-11 were the same as the installed ones I have on SuSE 10.2. Now the resolution of the external VGA outlet is still set to 1024x1024, but at least the missing five centimeters are displayed on the wall. (when I use 3c as the mode in /etc/sysconfig/videobios, when I use e.g. 30 as the mode in /etc/sysconfig/videobios, then three centimeters of the screen are missing at the left side) It doesn't make a difference, whether I configure 1024x768 or 1200x1024 for the external port. Always 1024x1024 is used on the external vga port. I also tried to use the system without the videobis hack. X11 starts up, with the wrong resolution on the Display, seems to be a 1280x1024, but not the 1680x1050. Therefore, I did an init 3, and started SaX2. It suggested the wrong resolution. Therefore changing the configuration, activating dual head mode, and 3D, I saw the correct resolution on the LCD, but on the external VGA output, still 1024x1024 (without the missing five centimeters on the left). with this configuration, after a reboot, the wrong (too low) resolution is used on the LCD screen. I cannot init 5 after using SaX, the X11 ends up with the error No screens found, I have to reboot, to be able to start X11 again. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.