Hi all, I am trying to automatically install a HP blade with autoyast. The hardware is componend of 4 ethernet cards. I am creating a custom iso file that is booted by HP ILO. isolinux.cfg contains : label BLADE kernel linux append initrd=initrd ramdisk_size=65536 netsetup=-dhcp Here is the info file I'm using : InstMode: http ##Instsys: boot/x86_64/root ##Install: http://10.0.0.1/sles10sp1/base/ Textmode: 1 AutoYaST: file:///autoinst.xml BrokenModules: qla2400,qla2xxx Gateway: 10.0.0.254 HostIP: 10.0.0.12 Netmask: 255.0.0.0 Netdevice: eth2 Server: 10.0.0.1 Serverdir: /sles10sp1/base/ I've copied this info file into the initrd. (I know InstMode is deprecated but I didn't add any success with Install: and Instsys: parameters) 1 - When the system boots, the system prompts again for IP settings. What I've did wrong ? What parameters I am missing ? When I swith to "F3" I see many "SIOCSIF..." failed on interfaces eth0, eth1. The network settings are then correctly reported and eth2 activated Then the installation process reports the following error "http error: 404 not found" 2 - The installation tell it is loading the image from "/sles10sp1/base/boot/root" The reported path is wrong. it should be "/sles10sp1/base/boot/x86_64/root/" (note the arch between boot and root) Is this a kown issue ? Any clues how to fix/ workaround it ? Thanks in advance, Regards, -Guy -- To unsubscribe, e-mail: opensuse-autoinstall+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-autoinstall+help@opensuse.org