[opensuse-autoinstall] Adding kernel parameters to the bootloader
Is there a straightforward means of appending additional kernel parameters to the bootloader (GRUB) kernel line without having to create a fully populated bootloader section? -- To unsubscribe, e-mail: opensuse-autoinstall+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-autoinstall+help@opensuse.org
* Lonni J Friedman [2008-05-26 13:06]:
Is there a straightforward means of appending additional kernel parameters to the bootloader (GRUB) kernel line without having to create a fully populated bootloader section?
Add them in the PXE configuration (e.g.) before starting the installation. The bootloader configuration in (Auto)YaST adds most parameters from there also to all bootloader sections. Bernhard -- To unsubscribe, e-mail: opensuse-autoinstall+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-autoinstall+help@opensuse.org
On Mon, May 26, 2008 at 01:06:51PM -0700, Lonni J Friedman wrote:
Is there a straightforward means of appending additional kernel parameters to the bootloader (GRUB) kernel line without having to create a fully populated bootloader section?
We use pxe to initiate the installs for our systems, and anything we pass then is carried over after install. So if it's not a problem to pass them then, you can just do that. -- Mike Marion-Unix SysAdmin/Staff IT Engineer-http://www.qualcomm.com "My chauffer was injured by a falling gargoyle while standing outside in Chinese footprints. We rang the bell, a woman screamed, a mouse ran by us, through the door. As you can plainly see, I miss nothing." Monsieur Perrier (James Coco) Murder By Death -- To unsubscribe, e-mail: opensuse-autoinstall+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-autoinstall+help@opensuse.org
participants (3)
-
Bernhard Walle -
Lonni J Friedman -
Mike Marion