Hi all I have had the same problem with the Eth0 not being picked up. However I am a Linux newbie and whilst having tried all the various forums I have not yet found the answer to the problem. I have a feeling it is likely to be something straight forward that I ma not doing!! The network card is on mobo Nvidia and I have updated the Nvidia drivers but without success. Any help would be gratefully received. Humvee -----Original Message----- From: Dennis Lyon [mailto:cdlyon@wi.rr.com] Sent: 22 September 2003 15:42 To: suse-autoinstall@suse.com Subject: [suse-autoinstall] SuSE 8.2 and NIC I had SuSE8.0 installed and working fine. I then did a new install on 8.2 and it doesn't activate the eth0 while 8.0 did. The hardware is the same and the eth0 works OK on other distros I have on the same machine. The bootlog shows: Setting up network interfaces lp0 done eth0 failed I attempt to fix through YAST2 but it shows the network interface as if it were OK, showing correct device and settings. How can I diagnose and fix? Thanks Dennis