Network Card autoinstall problem
Hi, I use SuSE Linux9 AutoYast for installation systems from my own created CD. The destination systems have different network cards, graphic cards, etc. Installation and configuration of the new system works fine incl. Graphic card, X11 etc. During the configuration also the network card is found, configured and useable. But after rebooting the system, the network is not useable since the module was not loaded. It seems to me that just the /etc/modules.conf was not setup right during the autoinstallation. Is there something wrong, or is there a way that I can do "repair" this with one of my post(chroot)-install scripts ? Regards, Bernhard -- | SAM Electronics GmbH | Dipl.-Ing. Bernhard Nöggerath | Software Navigation Systems, Dept. MST 21 | Kurfürstenallee 130 | D-28211 Bremen, Germany | | Phone: +49 421 1784 3513 | Fax: +49 421 1784 2026 | mailto:Bernhard.Noeggerath@sam-electronics.de
Hi, Can you post the network section of the control file you have used? Anas Bernhard Nöggerath wrote:
Hi, I use SuSE Linux9 AutoYast for installation systems from my own created CD. The destination systems have different network cards, graphic cards, etc. Installation and configuration of the new system works fine incl. Graphic card, X11 etc. During the configuration also the network card is found, configured and useable. But after rebooting the system, the network is not useable since the module was not loaded. It seems to me that just the /etc/modules.conf was not setup right during the autoinstallation. Is there something wrong, or is there a way that I can do "repair" this with one of my post(chroot)-install scripts ?
Regards, Bernhard
participants (2)
-
Anas Nashif -
Bernhard Nöggerath