Try looking at section 4.5 in the AutoYaST manual; hopefully this will help. -----Original Message----- From: Daniel Spannbauer [mailto:ds@marco.de] Sent: Wednesday, February 23, 2005 8:45 AM To: suse-autoinstall@lists.suse.com Subject: [suse-autoinstall] Installing Additional Software Hello, i'm working under SuSE 9.2. I've made a Config-File with Yast2, started an DHCP-Server, NFS-Server und TFTP-Server. I run Autoyast with PXE-Boot and it works very well. But now I wan't to install a Not-SuSE-Package auomaticaly after the SuSE-Installation is done. The rpm-File is at the same Path as the Suse-RPMs are (on a NFS-Share) How do I setup up this? Can I do this in Yast too? I'm not good in XML so a graphical Solution would be nice. Thanks Daniel -- Daniel Spannbauer EDV Systembetreuung marco Systemanalyse und Entwicklung GmbH Tel +49 8333 9233-66 Auf der Wies 8, D 87727 Babenhausen Fax +49 8333 9233-11 http://www.marco.de/ Email ds@marco.de -- To unsubscribe, e-mail: suse-autoinstall-unsubscribe@suse.com For additional commands, e-mail: suse-autoinstall-help@suse.com