Dear Sirs after reading the available documentation for autoyast, I am not sure if autoyast applies to my problem. (Suse 8.1 Pro) Contrary to many of you who have lots of machines with equal hardware to manage, I have a few machines to set up with different hardware. So I would really like to just 'save' and 'reload' my package selection from a master PC, and then interactively change and use it in the 'continue'-phase of the install, or even after the system has been installed to a minimal configuration. How would I go about this? Alternative question: where does Yast save the current package selection, and does it help to copy this over? Thanks Christian -- Christian Gnägi EDV-Beratung Ipsachstr. 16 CH-2563 Ipsach Tel: +41 32 3331351 Fax: +41 32 3331355 cg#gnasch.ch