Hi, I'm having a bit of trouble with remotely installing SLES10 (X86_64) over the network with post scripts defined. The profile I have works fine.... until I add this section for scripts: <scripts> <post-scripts config:type="list"> <script> <network_needed config:type="boolean">true</network_needed> <filename>test.sh</filename> <interpreter>shell</interpreter> <source><![CDATA[ #!/bin/sh ################################ # Setup script for new servers # ################################## # Add host entry for sudo server # ################################## echo "10.245.13.12 dserv-mgt sudo-host" >> /etc/hosts #################################################### ############################################## # Start up NFS and untar LINUX_NEWSERVER.tar # ############################################## mkdir -p /media/nfs /etc/init.d/portmap start mount 10.244.35.51:/depot/SUSE/i386 /media/nfs cd / tar -xvf /media/nfs/conf/S10LINUX_NEWSERVER.tar ]]> </source> </script> </post-scripts> </scripts> I even tried splitting it out, using location instead: <scripts> <post-scripts config:type="list"> <script> <network_needed config:type="boolean">true</network_needed> <location>http://10.244.35.51:/conf/scripts/SLES10.sh</location> </script> </post-scripts> </scripts> Doesn't matter what I try, I get the same results (thought it might be a network problem to start with). I even tried the above with the location line deleted and had the same error. I've even stripped the script down to a basic echo out to a file - same error. This, however, works fine under SLES9. The problem? After the first reboot, it detects the network card, goes on to perform 'installation', I briefly see a message about running scripts, then the hald stops with the error: /usr/lib/YaST2/startup/YaST2.call: line 306: 4074 Aborted The system has not been set up correctly (in-fact I can't even log in - I ended up using a screen capture to get the error message above). As soon as I remove everything from <scripts> to </scripts> all works fine again (the system installs correctly). Not sure what I am missing here..... Colin Ericsson Services Limited Registered Office: Unit 4, Midleton Gate, Guildford Business Park, Guildford, Surrey, GU2 8SG Registered Number in England and Wales: 3709800 This communication is confidential and intended solely for the addressee(s). Any unauthorised review, use, disclosure or distribution is prohibited. If you believe this message has been sent to you in error, please notify the sender by replying to this transmission and delete the message without disclosing it. Thank you. Ericsson Services Limited does not enter into contracts or contractual obligations via electronic mail, unless otherwise agreed in writing between the parties concerned. E-mail including attachments is susceptible to data corruption, interruption, unauthorised amendment, tampering and viruses, and we only send and receive e-mails on the basis that we are not liable for any such corruption, interception, amendment, tampering or viruses or any consequences thereof. ______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please visit http://www.messagelabs.com/email ______________________________________________________________________ -- To unsubscribe, e-mail: opensuse-autoinstall+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-autoinstall+help@opensuse.org