Hi All, I've got a setup with three RAID1 SATA disks, using grub as boot loader. All works fine except for one thing: I can only boot on the first disk. This is my boot loader definition in autoinst.xml: [snip] <bootloader> <global> <activate>true</activate> <generic_mbr>true</generic_mbr> <gfxmenu>/boot/message</gfxmenu> <timeout config:type="integer">5</timeout> </global> <loader_device>/dev/md</loader_device> <loader_type>grub</loader_type> <location>mbr</location> <repl_mbr config:type="boolean">true</repl_mbr> </bootloader> [snip] After successful installation, I can see that /etc/grub.conf only mentions the first disk, where it should mention all three. After reading the documentation, I'm still not wiser. If I fix it using YaST2 on the installed machine, all I have to do is to select "o Boot from Boot Partition", install the new bootloader, check out /etc/grub.conf, and sure enough, there's the three disks. What do I have to do to get autoyast to install the boot loader on all three disks, not just the first one? Or, what are the legal values for "<location>"? What am I doing wrong here? Any advice appreciated /Lars Stavholm -- To unsubscribe, e-mail: opensuse-autoinstall+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-autoinstall+help@opensuse.org