Good afternoon I'm currently setting up my config file for the autoinstall. Everything works fine, except for one thing. I always get the pop up if I want to use DHCP or not. "Automatic configuration via DHCP?" Yes, I want! But I'd like to have this set automatically. If I choose yes it continues until the installation is done, without any further problems. I tried adding the parameters DHCP=1, UseDHCP=1. Both at the same time and one without the other. Then I get the message that there was no network interface found, so I thought it might help if I add "insmod=tg3" to the parameters. No luck though. What do I have to do to use DHCP without the setup asking? Thanks in advance. André --------------------------------------------------------------------- André Hirschi Phone +41 44 366 88 43 Systems Administrator Fax +41 44 366 88 99 Visonys AG Mobile +41 78 626 22 09 Ottikerstrasse 59 andre.hirschi@visonys.com CH-8006 Zürich Switzerland www.visonys.com --------------------------------------------------------------------- safe and swiss.