Hi Emils Thank you very much, that did the trick. I don't quite understand why this is needed since there is only one ethernet device, but at least it works. Thanks again. Regards André Emils wrote:
Hey,
I had to increase dhcptimeout setting and also to specify which network interface to use, for this to start working:
dhcptimeout=180 netdevice=eth0
Regards, Emils
2006/7/21, André Hirschi <ahirschi@visonys.com>:
Good afternoon
I'm currently setting up my config file for the autoinstall. Everything works fine, except for one thing.
I always get the pop up if I want to use DHCP or not. "Automatic configuration via DHCP?" Yes, I want! But I'd like to have this set automatically. If I choose yes it continues until the installation is done, without any further problems.
I tried adding the parameters DHCP=1, UseDHCP=1. Both at the same time and one without the other. Then I get the message that there was no network interface found, so I thought it might help if I add "insmod=tg3" to the parameters. No luck though.
What do I have to do to use DHCP without the setup asking?
Thanks in advance. André
--------------------------------------------------------------------- André Hirschi Phone +41 44 366 88 43 Systems Administrator Fax +41 44 366 88 99 Visonys AG Mobile +41 78 626 22 09 Ottikerstrasse 59 andre.hirschi@visonys.com CH-8006 Zürich Switzerland www.visonys.com --------------------------------------------------------------------- safe and swiss.
-- To unsubscribe, e-mail: suse-autoinstall-unsubscribe@suse.com For additional commands, e-mail: suse-autoinstall-help@suse.com