Ave! I want to perform an installation on a machine with the following network configuration: eth0 connected on a 10.*.*.* subnet eth1 connected on a 192.168.0.* subnet eth0 is used to boot a linux image by pxe. eth1 is used to access SLES files by nfs. When the system is rebooted and autoyast is started, the SLES files are not found by autoyast. I suppose it is because autoyast uses the eth0 to get the SLES files, and in this case the eth0 is the PXE subnet. When I change the cables and eth0 becomes the SLES repository, it works. Is there some way to configure autoyast to recognize all subnets during its execution? Thus, I haven't care about the networks order. -- Jonathan Meller jonathan.meller@tteng.com.br ======================================================= Tools & Technologies - T&T Engenheiros Associados Ltda. Projetos de SW - Desenvolvendo soluções. Rua Riachuelo, 1098 Conj. 901 Centro - Porto Alegre - CEP 90010-272 Fone DDR: (51)3220-3268 Fone/Fax: (51)3220-3220 / 3220-3206 http://www.tteng.com.br/ tet@tteng.com.br =======================================================