On Tue, Jun 06, 2006 at 11:30:50PM +0200, Dejan Muhamedagic wrote:
Hello,
After successful (more or less) auto installation, the resulting network configuration on the target hosts consists of what was defined for netdevice in linuxrc and not what was configured in the autoyast XML file. The configuration is definitely good and autoyast reports no errors.
Is linuxrc wrong place to specify the network interface configuration for installation? Should one try with the info file?
The general idea is that yast2-network uses what is in the autoinstallation profile and if there is nothing there it uses the info from linuxrc (via /etc/install.inf). What exactly is set up differently than you expect? ifcfg, routing, resolver? Please post the appropriate part of autoinst.xml and install.inf.
This is on SLES9 SP3. Boot is from a CD, but the sources and autoyast files are accessed over HTTP.
which version of yast2-network?
BTW, I tried similar static network configuration, but with network boot using DHCP/PXE/tftp and the resulting network config was fine.
-- Martin Vidner, YaST developer SuSE CR, s.r.o. e-mail: mvidner@suse.cz Drahobejlova 27 tel:+420-296542390 190 00 Praha 9, Czech Republic http://www.suse.cz