Hello all, I would like to update an installed system with a new AutoYast XML profile (containing only updated stuff) and found that there is a /sbin/yast ayast_setup setup filename=profile.xml command that does just that. Unfortunately, the docs about what this command does exactly are very spare. Uwe mentions on http://suse.gansert.net/?p=38 that (quoting): ------- The XML file will be read by AutoYaST and applied to your currently running system except (and that’s good – you want it that way, believe me) all 1st stage configuration like partitioning, bootloader, pre- and chrootscripts and software selection. ------- => Thus, for software updates I use post-packages, => for scripts I wanted to use post-scripts and init-scripts. But it looks like init-scripts are not run... is there a complete list of steps that are actually done by this command? Background: I would like to use zypper to enable a repo with the XML mentioned above. But as it does not run the init-scripts and Yast locks the RPM database during post-scripts, I looks like zypper cannot be used along with "ayast_setup setup" at all, right? Best regards, Joschi Brauchle