Dear all, I am trying to solve a strange networking problem with PXE boot and SUSE. Here follows a description with the strange ARP broadcast noted at the end: 1) PXE boot the 10.205.8.253 (new server to install) 2) DHCPOFFER to 10.205.8.253 and this then sends a DHCPACK. 3) 10.205.8.253 then TFTP downloads the linux and initrd and executes it successfully. 4) Afterwards 10.205.8.253 looses all the network information. 5) The final messages (Xensourc) shown in Ethereal are ARP requests that come from 10.205.8.253. This is the autoyast server ARPing for the MAC of 10.205.8.253 because it has disappeared from the network. No. Time Source Destination Protocol Info 15120 22.480085 Xensourc_33:3f:cc d8:d3:85:5a:00:b0 ARP Who has 10.205.8.253? Tell 10.205.8.145 At this point the PXE booted system 10.205.8.253 then reverts to the screen for starting a manual set-up programme. "Could not find ... the Installation Source. Activating manual setup program." When I use this to display the network interfaces then it only displays the loopback. This problem is not specific to one server. It happens on all servers. The servers consist of existing HP c-class blades, and some newer G6 blades. I tried a CD installation on the former blades and this works, but Suse does not see the NIC on the newer G6 blades. I do know that the firmware for the OA on the HP c7000 was upgraded this week, it all worked last week, but this is process of elimination because, as ever, one has to prove to others that this is or is not a cause because otherwise the firmware won't be rolled back. Does anyone know where I would start? Perhaps, I could load modules during the PXE boot for the server NIC? Unsure how or whether this is the right path to start down. Yours sincerely, s. -- To unsubscribe, e-mail: opensuse-autoinstall+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-autoinstall+help@opensuse.org