Op dinsdag 23 juni 2015 18:40:50 schreef Freek de Kruijf:
Both have the same problem starting slow.
This was about Build325.3 for RPi1 and Build315.2 for RPi2. Today I found Build315.3 for RPi2. The slow start has gone.
The RPi2 system does not work.
On my TV screen I see that the kernel is loaded, after which the screen is wiped clean. I see the lights of the Ethernet port on and blinking, however after a while, a few minutes, the system starts again, showing messages about the boot process and finally that the kernel is loaded. Build308.3 for RPi2 is the last working system. It lacks however showing console messages about the start process after the kernel is loaded. It shows messages about the boot process, but after the messages about loading the kernel the screen becomes blankand after a while it show the system message and the log in prompt. Is it possible to display the start up of the system, like with the RPi1, where the whole process about repartitioning the SD card is shown and other start up messages? -- fr.gr. member openSUSE Freek de Kruijf -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org