This image at least boots: http://download.opensuse.org/ports/armv7hl/factory/images/openSUSE-Factory-A... However it fails to activate networking in general (no IPv4 address, no routes, no gateway, no resolv.conf - yes the LAN DHCP server works well), so it's still of no use. On what hardware have these images been tested? Thanks, Volker U-Boot SPL 2015.04-rc3 (Mar 09 2015 - 21:02:35) DRAM: 1024 MiB CPU: 1008000000Hz, AXI/AHB/APB: 3/2/2 U-Boot 2015.04-rc3 (Mar 09 2015 - 21:02:35) Allwinner Technology CPU: Allwinner A10 (SUN4I) I2C: ready DRAM: 1 GiB MMC: SUNXI SD/MMC: 0 *** Warning - bad CRC, using default environment HDMI connected: Setting up a 1280x1024 hdmi console In: serial Out: vga Err: vga SCSI: SUNXI SCSI INIT SATA link 0 timeout. AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl SATA mode flags: ncq stag pm led clo only pmp pio slum part ccc apst Net: emac starting USB... USB0: USB EHCI 1.00 scanning bus 0 for devices... 4 USB Device(s) found USB1: USB EHCI 1.00 scanning bus 1 for devices... 1 USB Device(s) found scanning usb for storage devices... 0 Storage Device(s) found Hit any key to stop autoboot: 0 switch to partitions #0, OK mmc0 is current device Scanning mmc 0:1... Found U-Boot script /boot.scr 2705 bytes read in 70 ms (37.1 KiB/s) ## Executing script at 43100000 switch to partitions #0, OK mmc0 is current device 6601032 bytes read in 719 ms (8.8 MiB/s) 42667801 bytes read in 3794 ms (10.7 MiB/s) 22591 bytes read in 204 ms (107.4 KiB/s) Kernel image @ 0x46000000 [ 0x000000 - 0x64b948 ] ## Loading init Ramdisk from Legacy Image at 4a000000 ... Image Name: Initrd Image Type: ARM Linux RAMDisk Image (uncompressed) Data Size: 42667737 Bytes = 40.7 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 49000000 Booting using the fdt blob at 0x49000000 Using Device Tree in place at 49000000, end 4900883e Starting kernel ... [ 0.000000] Booting Linux on physical CPU 0x0 ... [ 39.893308] systemd-udevd[1354]: starting version 210 [ 11.930660] Creating dracut based initrd [ 130.856442] device-mapper: core: cleaned up Image Name: Boot-Script Created: Fri Mar 13 01:02:05 2015 Image Type: ARM Linux Script (uncompressed) Data Size: 2547 Bytes = 2.49 kB = 0.00 MB Load Address: 00000000 Entry Point: 00000000 Contents: Image 0: 2539 Bytes = 2.48 kB = 0.00 MB skiped writing MBR ID for armv7l [ 132.368539] systemd[1]: systemd 210 running in system mode. (+PAM -LIBWRAP +AUDIT +SELINUX -IMA +SYSVINIT +LIBCRYPTSETUP +GCRYPT +ACL +XZ +SECCOMP +APPARMOR) [ 132.401255] systemd[1]: Detected architecture 'arm'. Welcome to openSUSE Factory (Tumbleweed) (armv7hl)! ... Welcome to openSUSE Factory "Tumbleweed" - Kernel 3.19.1-1-default (ttyS0). linux login: -- Volker Kuhlmann http://volker.top.geek.nz/ Please do not CC list postings to me. -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org