On Wed, 23 Nov 2016 14:00:11 +0100 Dirk Müller <dirk@dmllr.de> wrote:
Hi All,
over the last few days I've been pretty busy with enabling pre-configured appliances for ARMv7 and AArch64 on openSUSE Leap 42.2,
Hello, I tested JeOS on Cubieboard, Cubieboard 2 and Cubietruck. There is no other image variant so I installed JeOS, got serial console working, got LAN working, and tried to install a DE. In the end I tested only Enlightenment on Cubietruck which starts fine. There are a few observations - the initial installation displays progress on the serial console but not HDMI - this may be in part due to some [un]blank console attempt failing because it is targeting wrong device which I noticed scrolling past - there is no ACPI support. It is needed for the power button working properly or some alternate emulation needs to be supported bug 1012325 Thanks for bringing these. The boot is a bit slower than bare kernel without initrd but having one kernel for all boards and bootloader with relatively sane GUI helps a lot. Thanks Michal -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org