On 06/30/15 11:24, Freek de Kruijf wrote:
Op dinsdag 30 juni 2015 10:57:31 schreef Alexander Graf:
On 06/30/15 10:55, Freek de Kruijf wrote:
Earlier a second boot of a system generated with this build for Raspberry Pi 1B did not work. Now I have a system that works and can be booted again.
However trying to start a module with yast (ncurses), I tried network, software repositories and software all end in the following error message:
/sbin/yast: line 426: 19947 Segmentation fault $ybindir/y2base $module "$@" "$SELECTED_GUI" $Y2_GEOMETRY $Y2UI_ARGS
However 19947 in the above message differs with the type of module called and with the locale used.
The repository still does not contain the ruby 2.2 modules for libstorage. I build these modules, which went OK. I noticed gcc5 was used.
I will continue with this build to configure the applications I use. Do you think you could gdb the y2base binary to figure out where exactly it segfaults? Alex, I have no experience with gdb. I know it is used to debug and one can set breakpoints and step through the code, but that's all I know.
No worries, there's always a first time :). In this case, all we need is to attach to the program and then do 'bt' when we see the segfault.
I tried to run yast in one console and did "gdb -p process-id" in another after installing yast2-core-debugger. However it likes to have yast2-core- debuginfo which is not available. After giving a c in gdb and selecting software in the ncurses console, gdb continues with the following output:
(gdb) c Continuing. Detaching after fork from child process 20159. [Thread 0xb601f450 (LWP 20077) exited] [Thread 0xb631b450 (LWP 20076) exited] [Inferior 1 (process 20075) exited normally]
This means that the process was doing just fine, no segfault. So maybe a different PID was the one broken? Which PID did you attach to? According to the log, "y2base" is the application that faults. If you can't find it, try to attach strace -f to the yast binary to figure out which binary gets executed. The strace should also at least print out which PID segfaulted. Alex -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org