On 9/11/19 3:53 PM, Guillaume Gardet wrote:
From: Michael Ströder <michael@stroeder.com> Sent: 11 September 2019 13:55
On 9/11/19 1:47 PM, Guillaume Gardet wrote:
-----Original Message----- From: Michael Ströder <michael@stroeder.com> Sent: 11 September 2019 13:34
I'm running Tumbleweed on RPI1 (armv6). It does not boot after last upgrade to kernel from 5.2.10 to 5.2.13. During upgrade there were no error messages.
Did you update the kernel only, or the whole distribution (maybe including firmware)?
I did the usual full upgrade with zypper dup -l --no-allow-vendor-change --no-recommends
Did you run out of space, maybe?
No. There's plenty of space on the partitions: - The firmware partition still has 15MB available and 1.5M used. - On the OS partition (where's /boot) 4.9GB are still available.
If the rainbow screen is not display, this means that the firmware is not loaded/started properly. IIRC, there was a firmware update with latest snapshot.
Can I check whether the firmware files are complete?
I have some RPi1 on my desk, I will try to have a look by the end of the week.
Thank you. Ciao, Michael. -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org