Le 09/09/2013 13:26, Freek de Kruijf a écrit :
Op zaterdag 7 september 2013 00:56:28 schreef Freek de Kruijf:
Op zaterdag 7 september 2013 00:14:09 schreef guillaume.gardet@free.fr:
----- Freek de Kruijf <f.de.kruijf@gmail.com> a écrit : [...] What reports the file command on raw image? Made it again and the command reported a tar archive!!!. So I unpacked the tar archive and now it reports: openSUSE-RPi-image-20130906.raw: x86 boot sector; partition 1: ID=0xc, active, starthead 32, startsector 2048, 126976 sectors; partition 2: ID=0x83, starthead 8, startsector 129024, 3889152 sectors, code offset 0xb8
So in effect the .xz file is a .txz
and the command to write this image to an SD card is:
xzcat openSUSE-RPi-image-20130906.raw.xz | tar -x | dd bs=4M of=/dev/sdX; sync
where X points to the device with the SD card.
After this I could start the Raspberry Pi and logged in.
Sorry, it is my fault. I made a .tar.xz file and named it .xz only.
I found a problem after inserting a WiFi USB stick. It reported a non existing folder, /lib/modules/3.1.10-5-raspberrypi. There is an existing folder /lib/modules/3.11.0-rc4-5-default, so I made a symbolic link to have the first pointing to the last. This solved the problem of the error messages.
The WiFi USB stick is a Realtek Semiconductor Corp. RTL8188CUS 802.11n WLAN Adapter. So I tried "modprobe -i rtl8188ee", but I got several messages "Invalid module format". Should I make a bug report?
Try to install kernel-raspberrypi using zypper (and remove kernel-default also). It should solve your problems. Guillaume -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org