Is there any instrucution I could follow to compile the kernel or build a image for panda board B3 2014-02-21 5:36 GMT+08:00 Nishanth Menon <nm@ti.com>:
On 02/20/2014 07:19 AM, 孙钰 wrote:
The Uboot in Factory (u-boot 2014.01) works for RevB3, But the kernal fails....
Here follows the message: U-Boot SPL 2014.01 (Feb 05 2014 - 15:07:29) OMAP4460 ES1.1
U-Boot 2014.01 (Feb 05 2014 - 15:07:29)
CPU : OMAP4460 ES1.1 Board: OMAP4 Panda I2C: ready DRAM: 1 GiB MMC: OMAP SD/MMC: 0 Using default environment
Net: No ethernet found. Hit any key to stop autoboot: 0 mmc0 is current device SD/MMC found on device 0 2113 bytes read in 3 ms (687.5 KiB/s) Running bootscript from mmc0 ... ## Executing script at 82000000 mmc0 is current device 4690280 bytes read in 215 ms (20.8 MiB/s) 68363617 bytes read in 3077 ms (21.2 MiB/s) 23288 bytes read in 8 ms (2.8 MiB/s) Kernel image @ 0x80000000 [ 0x000000 - 0x479168 ] ## Loading init Ramdisk from Legacy Image at 82000000 ... Image Name: Initrd Image Type: ARM Linux RAMDisk Image (uncompressed) Data Size: 68363553 Bytes = 65.2 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 80f80000 Booting using the fdt blob at 0x80f80000 Using Device Tree in place at 80f80000, end 80f88af7
Starting kernel ...
on my non B3 board: http://slexy.org/view/s2YhugU4oW (3.13) http://slexy.org/view/s2mU9djKVq (3.14-rc3)
Looking at the dts, I guessed there are cs1 is being attempted, could someone with a B3 board try http://slexy.org/raw/s20dkh58XR out (not an official patch, just to get an idea). I am trying to get my hands to a B3 board to verify as well, but might take a few days.
-- Regards, Nishanth Menon
-- 孙钰 Address:北航新主楼F1015 -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org