Hi to all I try to setup openSUSE 13.1 on my Beaglebone Black. I follow the procedure described in this page: https://en.opensuse.org/HCL:BeagleBone_Black I choose the XFCE image (openSUSE-13.1-ARM-XFCE-beaglebone.armv7l-1.12.1-Build40.18). This works and it's cool; easy and powerful. The system start, and the yast configuration works (via serial console). But, even if the system seems to be perfectly working and the hdmi cable it`s connected to monitor, the monitor said me "No Signal" Someone have advice to let the monitor hdmi work correctly? I tried another image (openSUSE-Factory-ARM-E17-beaglebone.armv7l-1.12.1-Build224.4) but this doesn't boot and stops here Net: <ethaddr> not set. Validating first E-fuse MAC cpsw, usb_ether Hit any key to stop autoboot: 0 switch to partitions #0, OK mmc0 is current device SD/MMC found on device 0 2261 bytes read in 14 ms (157.2 KiB/s) Running bootscript from mmc0 ... ## Executing script at 82000000 switch to partitions #0, OK mmc0 is current device 5575752 bytes read in 353 ms (15.1 MiB/s) 57450503 bytes read in 3350 ms (16.4 MiB/s) 33138 bytes read in 33 ms (980.5 KiB/s) Kernel image @ 0x82000000 [ 0x000000 - 0x551448 ] ## Loading init Ramdisk from Legacy Image at 88080000 ... Image Name: Initrd Created: 2014-10-10 6:33:40 UTC Image Type: ARM Linux RAMDisk Image (uncompressed) Data Size: 57450439 Bytes = 54.8 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 88000000 Booting using the fdt blob at 0x88000000 Using Device Tree in place at 88000000, end 8800b171 Starting kernel ... Thanks in advance bye Alexjan -- Alexjan Carraturo -- Twitter/Facebook/Identica/flickr: axjslack Personal site: http://axjslack.wordpress.com -- -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org