Hi Oscar, On Mon, 26 Jan 2015 10:19:09 +0100 Oscar C <oscar-listas@naiandei.net> wrote:
El 2015-01-25 11:44, Stefan Botter escribió:
Hi all,
I am trying to run the cubietruck JeOS image from d.o.o://ports/armv7hl/factory/images/, but so far without success. I have the image on a sd card, and put both partitions also on a connected sata disk. As far as I can see the kernel starts, but everything comes to a sudden stop where - I believe - the init/systemd process should take over.
I also tried the 13.2 image, but that did not work either, for sure because of the uboot version (mentioned here on the list earlier).
Is there any magic to perform? Can I help?
Could you attach the output of the serial console?
The attached file is the log from reset of the board until the system is stuck, and after a reset I stoped the boot process and print the environment. Please tell me, if you need more information. I used openSUSE-Factory-ARM-JeOS-cubietruck.armv7l-1.12.1-Build257.8.raw.xz downloaded last Friday. Greetings, Stefan -- Stefan Botter zu Hause Bremen