Hello, could I ask if OpenSuse 13.1 works with beaglebone? I followed instructions on https://en.opensuse.org/HCL:BeagleBone_Black However I get as far as "Starting kernel" and then nothing else happens. Any ideas? U-Boot 2013.04 (Mar 17 2014 - 15:34:07) I2C: ready DRAM: 512 MiB WARNING: Caches not enabled NAND: No NAND device found!!! 0 MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 *** Warning - readenv() failed, using default environment musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Peripheral mode controller at 47401000 using PIO, IRQ 0 musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Host mode controller at 47401800 using PIO, IRQ 0 Net: <ethaddr> not set. Validating first E-fuse MAC cpsw, usb_ether Hit any key to stop autoboot: 0 mmc0 is current device SD/MMC found on device 0 1948 bytes read in 5 ms (379.9 KiB/s) Running bootscript from mmc0 ... ## Executing script at 80200000 kerneladdr=0x80200000 ramdiskaddr=0x81000000 mmc0 is current device 4500264 bytes read in 571 ms (7.5 MiB/s) 65308180 bytes read in 8153 ms (7.6 MiB/s) 21959 bytes read in 13 ms (1.6 MiB/s) ## Loading init Ramdisk from Legacy Image at 81000000 ... Image Name: Initrd Image Type: ARM Linux RAMDisk Image (uncompressed) Data Size: 65308116 Bytes = 62.3 MiB Load Address: 00000000 Entry Point: 00000000 ## Flattened Device Tree blob at 80f80000 Booting using the fdt blob at 0x80f80000 Using Device Tree in place at 80f80000, end 80f885c6 Starting kernel ... -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org