Am 26.08.2012 18:53, schrieb endym:
Am 26.08.2012 16:11, schrieb Alexander Graf:
On 26.08.2012, at 06:01, endym wrote:
Am 20.08.2012 12:04, schrieb Dirk �:
Hi,
over the weekend we've built 12.2 images and smoke-tested them on one board (Panda). The images are here:
http://download.opensuse.org/repositories/openSUSE:/12.2:/ARM/images/
We plan to announce them later as Release Candiate 1. If you own a Pandaboard, BeagleBoard or an EfikaMX, please give them a try. the Vexpress ones are iirc also completely untested so far. Any feedback (positive or negative) is highly welcome.
Thanks! Dirk
Hi Dirk,
just tried the image "LimeJeOS-openSUSE-12.2-ARM-panda.armv7l-1.12.2-Build9.4.raw.xz" on a Pandaboard ES. I have only checked if WLAN works. It does not. ifconfig does not list a wlan interface. I guess the error message "wl12xx: ERROR could not get nvs file ti-connectivity/wl1271-nvs.bin: -2" in the boot log could be a reason...
This looks like missing firmware. Where do we get this from?
Maybe here: <http://omappedia.org/wiki/Mac80211_based_open_source_architecture#Firmware_and_NVS_for_the_WLAN>
Apart from that I found this error message in the log: "leds-gpio: probe of leds-gpio failed with error -16".
Does the LED blink for you?
None blinking. Both LEDs are always on.
Alex
Regarding the LEDs: Maybe the GPIO numbers of the Pandaboard ES are different to the Pandaboard (without ES). For the ES the LEDs are GPIO_110 and GPIO_WK8. When I export gpio 110 in /sys/class/gpio/export I see that the direction is "in" instead of "out". After correcting this I can toggle the LED. Regards, endym -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org