SCSI problem on Tyan Thunder 2882
Hi NG, I have a problem with a 4 disk raid0 on a dual opteron tyan board. When copying large files, the kernel reports 'scsi0 transmission error detected' Where do I start sorting out the problems? Software or hardware problem? The board is a Tyan Thunder K8S Pro S2882, the drives are Fujitsu MAS3367NP. OS is Suse Linux 9.0 64bit The scsi controller is an on board aic7902w dual channel u320 scsi controller. In the bios, I enabled the termination. All 4 drives are connected to the scsi-a connector, there is a termination board at the last drive and the jumper on the drive is set to provide terminal power I placed the complete error messages at www.lucienet.de/scsiprob.txt Any help will be appreciated Arno
Arno Seitzinger <arno@lucienet.de> writes:
Hi NG,
I have a problem with a 4 disk raid0 on a dual opteron tyan board.
When copying large files, the kernel reports 'scsi0 transmission error detected'
Where do I start sorting out the problems? Software or hardware problem?
This sounds like a hardware issue.
The board is a Tyan Thunder K8S Pro S2882, the drives are Fujitsu MAS3367NP. OS is Suse Linux 9.0 64bit The scsi controller is an on board aic7902w dual channel u320 scsi controller. In the bios, I enabled the termination.
All 4 drives are connected to the scsi-a connector, there is a termination board at the last drive and the jumper on the drive is set to provide terminal power
I placed the complete error messages at www.lucienet.de/scsiprob.txt
Any help will be appreciated
Andreas -- Andreas Jaeger, aj@suse.de, http://www.suse.de/~aj SuSE Linux AG, Maxfeldstr. 5, 90409 Nürnberg, Germany GPG fingerprint = 93A3 365E CE47 B889 DF7F FED1 389A 563C C272 A126
participants (2)
-
Andreas Jaeger -
Arno Seitzinger