Hello all I would like to link my two laptops with a wifi network : PC n°1 : SuSE 9.2 Pro 64 bits, a wifi PC card built with chipset rt2500 (module rt2500 up to date) PC n°2 : SuSE 9.3 Pro 32 bits, a wifi PC card built with chipset rt61 (module rt61 up to date) On each PC, there are eth0 (ethernet) and ra0 (wifi) interfaces. The IP addresses are : PC n°1 : eth0 with 192.168.1.101 (mask 255.255.255.0), ra0 with 192.168.1.201 (mask 255.255.255.0), no gateway, mode Ad-Hoc and no WEP key for wifi. PC n°2 : eth0 with 192.168.1.102 (mask 255.255.255.0), ra0 with 192.168.1.202 (mask 255.255.255.0), no gateway, mode Ad-Hoc and no WEP key for wifi. On PC n°1, there is an ADSL modem, plugged on eth0 and whose IP address is 192.168.1.1. About firewall, ra0 is put in internal area without protection on each PC. Normally by doing a ping -I ra0 192.168.1.202 from PC n°1, I should get an answer ... like by an ethernet cable link. But NO !!! I get this : ping -I ra0 192.168.1.202 PING 192.168.1.202 (192.168.1.202) from 192.168.1.101 ra0: 56(84) bytes of data. From 192.168.1.201: icmp_seq=2 Destination Host Unreachable From 192.168.1.201 icmp_seq=2 Destination Host Unreachable From 192.168.1.201 icmp_seq=3 Destination Host Unreachable From 192.168.1.201 icmp_seq=4 Destination Host Unreachable From 192.168.1.201 icmp_seq=6 Destination Host Unreachable That's curious. No better effect with a gateway 192.168.1.201 put on PC n°1. Am I forgetting something in network configuration ? If I put a name in ESSID for PC n°1 for example, from the other PC I can see the name. So it seems that wifi on each PC is OK but something is missing or is not properly working. Any idea ?? A problem of firewall ? I put ra0 of each PC in internal area, so it should not be a problem at this level. But .... Thanks Pascal --------------------------------------------------------------------- To unsubscribe, e-mail: opensuse-amd64+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-amd64+help@opensuse.org