Andi, Thank you for the advice. This is the start of a new web set of web servers we are rolling out over the next six months. I was hoping to start clean with Apache 2, but maybe not. So, I suppose this applies also to binary file from Apache Foundation httpd-2.0.48-x86_64-unknown-linux-gnu.tar.gz found at: http://www.apache.org/dist/httpd/binaries/linux/ ?? Also, what type of things might need to be fixed if I compiled from source? Thank you again - Richard -----Original Message----- From: Andi Kleen [mailto:ak@suse.de] Sent: Monday, March 01, 2004 5:39 PM To: Richard Mixon (qwest) Cc: suse-amd64@suse.com Subject: Re: [suse-amd64] Help Installing SuSE 9 AMD64 Apache2 rpms with yast2 on SLES 8 AMD64 On Mon, 1 Mar 2004 16:52:52 -0700 "Richard Mixon (qwest)" <rnmixon@qwest.net> wrote:
I am sure this is a SuSE yast2 newbie problem. But I have read and re-read the SLES 8 for AMD64 installation manual, The SuSE 9.0 installation manual and I have Googled for hours already. Help is appreciated.
The specific problem is with Apache2, but I believe I should be using yast2 for all of my RPM installs, if I understand correctly.
I downloaded the Apache2 rpms for SuSE 9.0 AMD64 from SuSE'S ftp site, expecting/hoping to be able to install them on my SLES 8
for You cannot directly install 9.0 RPMS on SLES8. The 9.0 RPMS require a newer glibc. Updating glibc is not trivial and has some traps. In addition apache has lots of references to other packages, so if you fulfilled all dependencies you would end up with half of the 9.0 in your SLES8 and likely quite some breakage. The better way probably would be to recompile the source rpm on SLES8. Even with that you will likely need to fix quite a few things by hand. -Andi -- Check the List-Unsubscribe header to unsubscribe For additional commands, email: suse-amd64-help@suse.com