On Tuesday 06 June 2006 01:44, David Bottrill wrote:
On Tuesday 06 June 2006 01:16, Jerry Westrick wrote:
And how does one go about setting up a XEN Server using SUSE 10.1 (pay version)?
I heard that the YAST config for xen should be fixed, but how to use it is still beyond me...
What I want to do is run sub doms, one is a backup for a server, the second a development environment...
Any suggestions on where/what to read?
Or how to set it up?
Ideally you need to install the Xen bits and pieces when you initially install SuSE 10.1 as this automatically sets up grub to support Xen as a boot option. It may do this after the event in 10.1 if you install Xen from Yast, but I haven't tried.
did that...
If you Google around there is plenty of documentation to be found.
I've got the following links: http://en.opensuse.org/Xen http://en.opensuse.org/Xen3_Status_and_Updates http://en.opensuse.org/Installing_Xen3 http://en.opensuse.org/Virtualization_Resources_for_SUSE_Linux http://en.opensuse.org/Xen3_and_a_Virtual_Network http://en.opensuse.org/Xen_Full_Virtualization_Example
Everything you need for Xen in on the SUSE disks open or paid version. If you look at the application selections in the Yast package manager there is a selection called Xen just select it and off you go.
done for me by installation...
Before you create a virtual machine you need to have booted the host machine with a Xen aware kernel (select this in Grub), from then on you can use the Xen install option within YAST.
I have a SUSE install directory on my NFS server and always install VMs from this as a network install source. You can in theory install from local CDs/DVD on you host machine but this wasn't very reliable in some of the release candidates and I haven't tried it with the released version.
I've copied the DVD to a local directory, but know how to setup a NFS share for this purpose, good tip Thx.
The Yast Xen installer gives you options for setting up a VM, I suggest you initially accept the defaults, you may however want to change the size and location of the virtual disk file, I think the default is 4GB.
Hmmm, I don't seam to find this one.... The documents talk about setting up a disk, and using loop dev, and install into directory... Is this what you mean? Ahh, I see under Yast2->system->XEN->add... Got you...
Once you have one or more Xen VMs up and running you can stop and start them and connect to the console from within Yast although it's pretty simple to do this from the command shell and you have far more utilities available to you this way.
I started out the hard way hand crafting VMs with SUSE 10.0 it's a lot easier now in Yast but it does help if you understand the basic principles and the format of the configuration file you need to define and start a VM. This knowledge has enabled my to get Debian and SUSE 9.3 VMs running on my server, although I did need to use VMware to get the base installs working in the first place.
David
--
Thx David, will give it a try and see how it goes... Jerry -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com