Mailinglist Archive: opensuse (4570 mails)

[meister@xxxxxxxxxx]

Am Montag 31 Oktober 2005 19:48 schrieb Christian Praeger 
<christian.praeger@xxxxxxxxxx>:
> meister@xxxxxxxxxx schrieb:
> >Am Montag 31 Oktober 2005 13:59 schrieb Christian Praeger
> ><christian.praeger@xxxxxxxxxx>:
> >>now Capi 2.0 works. But now I have another problem:
> >>I want to use Capisuite to receive fax. Sometimes it works fine and
> >>sometimes I don't get a fax and this error in the capisuite.log:
> >>I took a look at the capisuite manual: The code 0x3400 means that
> >> the ISDN protocol is ok and the transmission terminated normally.
> >> But the error code 0x3311 says that the connection was not
> >> successful and the remote station is not a G3 fax device??
> >is it really a G3 (analog usual) fax? Or is it G4 (ISDN unusual,
> > because too expensive)?
> Yes, the sender is a normal analog faxdevice.

Hi Christian,

hmmm, maybe the module is broken? What modules are shown up in the 
output of "lsmod"?

> >>On Suse 9.2 it worked with the same hardware. What's wrong in
> >>Opensuse 10?
> >What did you select in YaST HylaFAX or CAPI2.0 (9.3 and 10.0)?
> I used in Suse 9.x the Capi interface and in 10.0 too.

Did you try the HylaFAX driver?

> if I send a fax from a ISDN card the fax is ok. Has the Capi 2.0
> driver any problems with G3 faxes?

Maybe. I have no FAX to test it. Search bugzilla and if you do not found 
anything, file a bugreport. (and please, do not top-post)

-- mdc