Hi Everyone, No flames please - I'm at work and I have access to Win 'xx only, and if I get my internal modem (i810 board) working soon I would be able to use my SuSE installation to send mails. I had request earlier how I could use the config file generated by YaST 2 the nextime i'm building a server - any clues? It reads the config file at boot i.e Floppy in the drive and boot off the CD1 but then how do I get past the screen of type of installation - "minimal/default/almost everything" - I need to build a few servers running the same services. 2. If I carry out the installation using YaST it is unable to read the file generated using YaST 2. 3. I'm also using a ISDN terminal adapter and unable to configure the same using YaST, the wvdial goes by its preset values, so I tinkered with the wvdial.conf and gave the init string but where do I give it the hangup string ? How can I overcome these problems? Greetings and thanks in advance!! - maneesh -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/support/faq