Here is my advise, which may be illegal to follow where you are.
Download the freetype2 sources from http://www.freetype.org and
recompile the freetype libraries with bytecode interpreter enabled.
(Read the instructions with the freetype2 sources to figure out how to
do that). Install this libraries. You may want to download the same
version of freetype2 as already installed on your linux. you can find
that by doing
rpm -qa | grep freetype2
most likely it is 2.1.7 for Suse 9.1 but I am not 100% sure about it.
Just double-check it.
Now, download MS Free Truetype fonts (I think it is available from
sourceforget - the project is called msttffonts or something similar).
Use the MS Free truetype fonts.
Also, make sure that the DPI is 96x96. Run xdpyinfo and search for
dots per inch. If it is not 96x96, chances are that font rendering
will not be it's best. You can specify the DPI by the --dpi argument
to X .
Osho
On Sun, 3 Oct 2004 11:19:11 +0200, dr.andreas.schenk@gmx.net
Hi,
last week I bought a new monitor and up to know I do not get a satisfactory display with fonts. Apart from that, the monitor is great.
I have SuSE linux 9.0 with KDE 3.1.4. My monitor is an EIZO L985EX with 1600x1200 Pixels @ 60 Hz (DVI). My graphics card is Matrox G450-23c3, if that matters.
With KDE I use the "standard" fonts Sans and Nimbus Sans L with sizes 12pt and 13pt respectively. If I switch off Anti-Aliasing, the letters look really ugly. If I switch it on, they are heavily blurred. I have tried Sub-Pixel-Hinting of all four kinds. The best result was archived with vertical RGB, but the letters are still blurred to much. They have blue (or green) and read (or orange) shadows below and above horizontal lines.
I tried other fonts. Some have the same problem, others do not at all. The latter are realy black and sharp with no shadow at all. I do not understand, why only some fonts have this problem. On the other hand, letters of fonts that do not have this problem, are not easy to read for other reasons, so I would like to stay with Sans and Nimbus Sans L.
What can I do (if anythig?).
By the way: In trying out other fonts with some applications, I got another problem:
With terminals (the console) the default font was Sans / Nimbus Sans L by default. I can change the font, but then I cannot set it back to Sans. The font is not offered! Other applications, e.g. Konqueror, do offer Nimbus Sans L to switch back to. How can I do the same with the console?
Thanks in advance for any help,
Andreas.
-- To unsubscribe, email: suse-kde-unsubscribe@suse.com For additional commands, email: suse-kde-help@suse.com Please do not cross-post to suse-linux-e