Reply on 11-12-2006 12:15:13 <<<
Quoting Dominique Leuenberger
: Hi,
I enabled the Remote Administration inside Yast, and I can connect
using a VNC Viewer to it. BUT: I only get a gray screen. Looks like
the GDM but without the login screen or an interface at all.
How can this be solved? Known bug? New bug to be entered?
Dominique
-- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org
Did you finished also the second part of configuration of VNC in SaX
?
Errmm.. no ? and even worse.. I can not start sax2 :~( it seems to dislike some modifications the vmware-config.pl did inside the xorg.conf... very very bad... More help is needed. Dominique -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org
Quoting Dominique Leuenberger
Reply on 11-12-2006 12:15:13 <<<
Quoting Dominique Leuenberger
: Hi,
I enabled the Remote Administration inside Yast, and I can connect
using a VNC Viewer to it. BUT: I only get a gray screen. Looks like
the GDM but without the login screen or an interface at all.
How can this be solved? Known bug? New bug to be entered?
Dominique
-- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org
Did you finished also the second part of configuration of VNC in SaX
?
Errmm.. no ? and even worse.. I can not start sax2 :~( it seems to dislike some modifications the vmware-config.pl did inside the xorg.conf... very very bad...
More help is needed.
Dominique -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org
OK, nevermind, it can be done by hand.... But it's better to restore some older xorg.conf and use Sax to do this changes. There are some parts of my xorg.conf. You can use some lines : Section "Module" Load "dbe" Load "type1" Load "freetype" Load "extmod" Load "glx" Load "v4l" Load "vnc" EndSection Section "Device" BoardName "GeForce2 MX/MX 400" BusID "1:0:0" Driver "nv" Identifier "Device[0]" Option "usevnc" "yes" Option "rfbauth" "/root/.vnc/passwd" Screen 0 VendorName "NVidia" EndSection Section "ServerLayout" Identifier "Layout[all]" InputDevice "Mouse[1]" "CorePointer" InputDevice "Keyboard[2]" "ExtraKeyboard" InputDevice "Mouse[3]" "ExtraPointer" Option "Clone" "off" Option "VNC" "3 2" Option "Xinerama" "off" Screen "Screen[0]" EndSection More help can be found on homepage of Xvnc. THere is some howto. M. ---------------------------------------------------------------- This message was sent using IMP, the Internet Messaging Program. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org
participants (2)
-
Dominique Leuenberger
-
linux@mejdan.org