On Sunday 29 February 2004 06:39 pm, Hans Forbrich wrote:
Hi,
I just added an Adaptec 29160 and a used Benchmark VS80/DLT1 (aka Quantum VS80 & Dell PowerVault 110T) to my SuSE SLES8 machine. On boot I get the message at the bottom (as well as other messages - don't want to clutter this list).
Any comments, advice, etc. appreciated.
TIA/Hans
from DMESG ....
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.29
aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs blk: queue f7fbde14, I/O limit 4095Mb (mask 0xffffffff) scsi0:A:3:0: DV failed to configure device. Please file a bug report against this driver. (scsi0:A:3): 20.000MB/s transfers (10.000MHz, offset 15, 16bit) Vendor: BNCHMARK Model: DLT1 Rev: 391B Type: Sequential-Access ANSI SCSI revision: 02 blk: queue f7fbda14, I/O limit 4095Mb (mask 0xffffffff)
Have you checked all of the settings on the controller? And were there any error messages during POST at boot up? -- +----------------------------------------------------------------------------+ + Bruce S. Marshall bmarsh@bmarsh.com Bellaire, MI 02/29/04 18:52 + +----------------------------------------------------------------------------+ "The two most important tools an architect has are the eraser in the drawing room and the sledge hammer on the construction site." - Frank Lloyd Wright