On Mon, 2013-05-13 at 16:11 -0400, Cristian Rodríguez wrote:
El 13/05/13 12:47, Roger Oberholtzer escribió:
I did a clean install. With erst_disable, it now reboots and gets to Automatic Configuration.
OK, does it keep the erst_disable in the boot line after reboot ?
At that point it fails. In GUI mode, I can only
see that it stops at 19%. I did a text-based trial, and, as reported earlier, that one stopped when it was looking for DSL stuff in the Automatic Configuration step.
Did you tried massive axe acpi=off and see if the installation finishes ?
That did the trick! So, it seems that during install I need: erst_disable acpi=off and during later use: acpi=off The only thing that remains is that when the system is shut down, the power to the PC does not go off. Maybe this is because of the acpi=off option. Otherwise, all our other SuperMicro units power off completely.
Also do you have any sort of custom BIOS configuration ? try using "setup defaults" or "optimized setup defaults".
The BIOS is pretty much in the default state. Yours sincerely, Roger Oberholtzer Ramböll RST / Systems Office: Int +46 10-615 60 20 Mobile: Int +46 70-815 1696 roger.oberholtzer@ramboll.se ________________________________________ Ramböll Sverige AB Krukmakargatan 21 P.O. Box 17009 SE-104 62 Stockholm, Sweden www.rambollrst.se -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org