Hello List, since a few i´m trying to find out why i have no Network with VMware4.5.2 on my RC1 Host. Probably somebody of you Guys got the same Configuration, and can help me to find out if the Problem is a VMware Module Problem or a Network Configuration Prob. Here is the Configuration which i also use successfully on SuSE 9.1. The Host has two NetworkCards, a Realthek for DSL and a nForce Onboard Chip for Local Network and VMware. Both Cards are configured. The nForce Onboard Card as eth0 with 192.168.2.1 The Realthek as eth1 with 192.168.100.99 Booth Cards are loadet on boot IP Forwarding is on, and set to 192.168.2.1 as default Gateway. I installed VMware as RPM, patched it with the any2any Patch 94, compiled the Modules for Bridged and Host-Only to eth0, and everything worked fine so far ... I can start VMware to install a OS from CD, but i don´t get any Network Connection inside the Virtual Machine, no Internet and no Samba ... So i was searching for the different between the Configuration of SuSE 9.1 and RC1, but everything is exactly the same. As next i compiled the nforce driver from NVIDIA, no effect ... Then i tried to install a Network Installation of Sarge in VMware, no network... So it´s not the Installed virtuell OS which has no network, it must be the Card itself, or the connection between the Card and vmnet0. Here is my question now. Has anybody VMware 4.5.2 on RC1 with Network running, or has anybody any idea where i can look next before i ask on the VMware Board ... As i said, i´m not shure if the Problem is a Network-Configuration Problem, or a VMware Prob. Thanks Michael